I designed this Advent calendar in the shape of the Deathly Hallows from Harry Potter. This was my first design project so hope you like.
I printed my one in PLA Wood on a Flash Forge Creator Pro.
Due to the size I had to make the sides in 6 pieces and glue together. I used Gorilla Glue as the surface wasn't flat enough to use Superglue.
I added the wand from "Sancharizard" just scaled down to 100mm long. This can be used to pull the drawers open if stuck.
I added a piece of white card to the back to stop the drawers pushing through.
The numbers were highlighted with a metallic pen.
| Bottom_Left.stl | 684.0B | |
| Bottom_Right.stl | 684.0B | |
| Left.stl | 684.0B | |
| Number_1.stl | 11.4KB | |
| Number_10.stl | 27.0KB | |
| Number_11.stl | 12.6KB | |
| Number_12.stl | 32.7KB | |
| Number_13.stl | 24.5KB | |
| Number_14.stl | 20.0KB | |
| Number_15.stl | 27.1KB | |
| Number_16.stl | 39.6KB | |
| Number_17.stl | 14.5KB | |
| Number_18.stl | 22.2KB | |
| Number_19.stl | 40.3KB | |
| Number_2.stl | 27.7KB | |
| Number_20.stl | 42.7KB | |
| Number_21.stl | 28.2KB | |
| Number_22.stl | 44.2KB | |
| Number_23.stl | 40.1KB | |
| Number_24.stl | 39.9KB | |
| Number_3.stl | 16.3KB | |
| Number_4.stl | 15.9KB | |
| Number_5.stl | 22.8KB | |
| Number_6.stl | 35.5KB | |
| Number_7.stl | 14.3KB | |
| Number_8.stl | 13.8KB | |
| Number_9.stl | 36.8KB | |
| Right.stl | 684.0B | |
| Stone_Bottom.stl | 35.8KB | |
| Stone_Top.stl | 36.2KB | |
| Top_Left.stl | 684.0B | |
| Top_Right.stl | 884.0B | |
| Wand.stl | 884.0B |
