This is a simple mod for sargentmyself's DC-17 holster that has both strap loops to allow you to attch the holster to a belt, and a top, rounded part that makes the holster look a little more accurate to the holster seen on Battlefront 2's ARC Troopers.
The strap loops were designed to fit 1.5 inch nylon webbing which is very durable, looks the part, and can easily be found online.
Here are some links to nylon webbing found on Amazon:
https://amzn.to/2WLQbuh - heavyweight nylon webbing
https://amzn.to/2XbHR5T - lightweight nylon webbing (less expensive)
To attach the pieces to the holster, I recommend using superglue and baking soda, and sanding any surface that will make contact with another part, this will ensure that the pieces are very strongly attached to the holster, making it less likely to break. Be careful though, because the reaction between the baking soda and glue will heat up a little)
If you use this method, you'll probably find out that when the glue hardens from the baking soda, it'll be harder and stronger than the printed plastic itself.
I haven't actually printed this mod for the holster yet so good luck if you beat me to it.
| dc-17_holster_printable_webbing_loop.stl | 263.8KB | |
| dc-17_holster_rounded_top_piece_mod_v2.stl | 35.2KB |
