This is setup for one 60mm and one universal 60-85mm spool. The post to hang the spool is lower than any other designs I found on Thingiverse. The HatchBox spools I user are taller and needed this modification. It also has a tighter fit between wall ribs, so it holds steady. This is currently setup on an XYZ Da Vinci 1.0.
Hope you like it.
Use the filament guides from here: http://www.thingiverse.com/thing:592197
| Davinci_Inside_Spool_Holder.3w | 465.7KB | |
| Davinci_Inside_Spool_Holder.stl | 33.1KB | |
| Davinci_Inside_Spool_Holder_Right.3w | 423.7KB | |
| Davinci_Inside_Spool_Holder_Right.stl | 29.7KB |
