This is a remix of @funkjan awesome work
However I did clean up some bad shape artefacts, made it more friendly to print without supports and prepared pieces slice for easy print, as the whole model was not fitting and cutting it in a slicer is not friendly.
Made option for Matek M10Q GPS (16x16) which is smaller then original hole (20x20) and made holders for screws to secure GPS unit
| Dart-XL-Rear-Cover-Bottom-GPS-16.stl | 793.6KB | |
| Dart-XL-Rear-Cover-top.stl | 678.7KB | |
| Dart-XL-Rear-Cover_Bottom.stl | 763.0KB |
