I extracted Death from Darksiders 2, I didn't print it yet but I will do it tomorrow and I will share.
when you put it in Cura it will be very big, so you may wanna adjust the scale.
I personally set the z-axis around 5-7 cm, it will take like 1 hour to print.
anyone is invited to take a test and tell me how it looks like
Update: I had scaled to about 38.00 mm to fit directly in the slicer. I will keep trying to fix the mesh until I get it nice.
Update 2: BIG NEWS !!!
Update 3: I've added the model for Death full, and without hair, and the hair separately. read the description for printing.
Update 4: I added the axe with blade dissembled, there are 9 parts, 8 blades, and the axe itself, I made this for the dissembled model I will ad later. Those could be printed at a larger scale and glued together, later on, I shall add holes in the axe handler for the magnets in order to be attached to the Death model
Update 5: I just added Death model splited in parts in order to be able to be printed in bigger size and glued toghether.
| Axe_full.stl | 175.1KB | |
| Axe_without_blades.stl | 152.2KB | |
| Belt.stl | 73.7KB | |
| Blade_1_bottom.stl | 3.0KB | |
| blade_1_top.stl | 4.2KB | |
| blade_2_bottom.stl | 3.0KB | |
| blade_2_top.stl | 4.2KB | |
| blade_3_bottom.stl | 3.0KB | |
| blade_3_top.stl | 4.2KB | |
| blade_4_bottom.stl | 3.0KB | |
| blade_4_top.stl | 4.2KB | |
| Death_Full.stl | 1.2MB | |
| Death_hairless.stl | 1.0MB | |
| Death_legs.stl | 251.6KB | |
| Death_upper_body.stl | 216.1KB | |
| Hair.stl | 64.5KB | |
| Left_hand.stl | 73.3KB | |
| right_hand.stl | 40.1KB |
