I am a fan of dark souls and always liked the armor design of it. I decided to print a wearable version of the silver knight helmet.
I had to cut it in parts to print it because the entire helmet was too big to fit in my printarea. Everything is edited and ready to print. Enable support or it will not work. I printed everything with PLA and assembled everything together with a soldering iron.
You just need to print it big enough to fit your head. In slicer scaling 20 is for children, 25-28 is for adults and if you got a bigger head print it on a 30 scaling.
You are not allowed to use this in any commercial way! This is a fanmade work! Dark souls and everything related to it belongs and is licensed to "FROM SOFTWARE".
| silver_knight_helmet_original.mtl | 168.0B | |
| silver_knight_helmet_original.obj | 50.1KB | |
| SK_bottom_1.stl | 4.1KB | |
| SK_bottom_1_left.stl | 4.1KB | |
| SK_faceplate_1.stl | 7.1KB | |
| SK_faceplate_2.stl | 8.9KB | |
| SK_faceplate_3.stl | 16.9KB | |
| SK_middle_1.stl | 4.7KB | |
| SK_middle_1_left.stl | 4.7KB | |
| SK_middle_2.stl | 4.4KB | |
| SK_middle_2_left.stl | 4.4KB | |
| SK_toph_1.stl | 11.2KB | |
| SK_toph_1_left.stl | 11.2KB | |
| SK_toph_2.stl | 4.2KB | |
| SK_toph_2_left.stl | 4.2KB | |
| SK_wing_left_1.stl | 11.0KB | |
| SK_wing_left_2.stl | 11.8KB | |
| SK_wing_left_3.stl | 2.6KB | |
| SK_wing_right_1.stl | 9.5KB | |
| SK_wing_right_2.stl | 11.8KB | |
| SK_wing_right_3.stl | 2.6KB |
