I designed this simple caliper.
I don't have a 3D printer, so I would like to go to FabLab to print this.
The only problem is that I don't know if this caliper will work or if it will be printed in a good way.
Can you tell me if this is a good project or if there is something to changed?
The caliper is in CM (centimeters) from 0 cm to 14 cm.
The number or the centimeters are written in Roman numbers.
Thank you!
ENJOY!
| Caliper_Dan_Male.stl | 190.3KB | |
| Caliper_Male_Dan.dae | 677.3KB | |
| Caliper_male_Dan.skp | 357.4KB | |
| Caliper_normal_Male.dae | 636.4KB | |
| Caliper_normal_Male.stl | 179.2KB | |
| Caliper_Pieno_male.skp | 344.2KB | |
| Cover_stretta_bene.dae | 44.8KB | |
| Cover_stretta_bene.skp | 397.1KB | |
| cover_stretta_bene.stl | 15.4KB |
