A pretty straightforward print for holding your dab pen straight up and down. My girlfriend and I were constantly knocking over the dab pen upon setting it on the desk so here's my solution to that.
I made mine out of PLA so I went with the basics for mine, 215 for my extruder and 75 for my bed. I did print with a brim to prevent any kind of warping.
The bottom half can fit about 20 pennies in it, I do recommend filling it to the top for the most weight.
Finally, I finished it off with 4 #6 screws, the hole diameter is .16 and I printed mine off before I finished the model. If the #6 doesn't fit, just use a #8 and it should be fine.
| Dab_Pen_Holder.stl | 945.6KB | |
| Dab_Pen_Holder_Base.stl | 176.0KB |
