I remade my D1 Wemos mini case.
It is for a D1 with micro USB connector.
( I don't have a USB-C version but the changes should be minimal. )
It now snaps together. No screws.
The version 5 lid is just a tiny bit easier to snap, I would try that one first.
Put the two teeth in first then snap down the back, i made it so that the top can slide to the side about a sixteenth of an inch so that you can have a bit of a lip to pry it open with your fingernail.
It is smaller so it uses less filament and less time to print.
Note that the usb connector is oriented down when installing the D1 into the case.
Like my other cases, it hangs from the 5 volt power cube on the AC receptacle;
ESP8266 https://www.thingiverse.com/thing:6532569
D1 mini https://www.thingiverse.com/thing:6546733
ESP8266 with RCWL https://www.thingiverse.com/thing:6544638
| D1_snap_bot.stl | 22.4KB | |
| D1_snap_lid_4.stl | 21.3KB | |
| D1_snap_lid_5.stl | 21.9KB |
