Simple case for ESP8266 wemos D1 mini.
With the micro usb connector.
Just drill holes for temperature or SW420 or flame sensor wires.
Hangs from wall plug.
Uses two 2mm x 8 screws.
Uses a small amount of filament and screws.
As shown in the picture a DS18B20 sensor is attached. I find that if the temp sensor is closer than about 5 inches to the ESP it is affected by the heat of the ESP.
Like my other cases, it hangs from the 5 volt power cube on the AC receptacle;
ESP8266 https://www.thingiverse.com/thing:6532569
D1 mini https://www.thingiverse.com/thing:6546733
ESP8266 with RCWL https://www.thingiverse.com/thing:6544638
D1 mini snap case https://www.thingiverse.com/thing:6547710
| D1_esp8266_body.stl | 55.8KB | |
| D1_esp8266_lid.stl | 22.9KB |
