This is for the airsoft CZ P09 mag end cap.
File Alpha is a smaller paw.
File Beta is a bigger paw.
Print with supports on as the rail to slide the mag is 90 degrees hang. You can try printing it upside down with no support. I haven't tried that yet. It's a tight fit on my mags and requires some knocking to get it to sit flush forward (if it's not flush forward it might not allow the mag to lock in place into the mag well).
The preview shows some texturing on the paw. If you print on ok or good quality settings then it will hardly show on the print.
Mirror the object to get the right paw.
Thank you to @alice3021 for making the finger cat paw!
| CZ_P09_PAW_end_cap_25mm_ALPHA_v8.stl | 335.3KB | |
| CZ_P09_PAW_end_cap_25mm_BETA_v5.stl | 303.8KB |
