9/21/2024 Added two Savage labeled lids and one blank lid.
2/22/2024 Advised this box will also hold Savage Mark II 10 round magazines.
8/7/2023 I added a version 3 of the mag box. The previous version is a tight fit. Version 3 adds 4mm to the box height allowing more room between base of magazine and lid.
12/6/2023 Added a lid with CZ 452 marking
This is a box with slide in lid designed to hold five 22LR magazines, loaded or unloaded, for a CZ457. There is an additional front compartment to hold notes on ammo, small tools or in this case, my Leatherman Squirt. The lid slides on and off very easily. If you want a tighter lif fit, you might increase it’s size 1 or 2 percent on the X axis in your slicer and hand fit, or just stick a small foam block in the front compartment to give a bit of drag.
if someone would like me to change the lid to reflect a CZ 455 or 452, ask and I will make one up.
This was designed to print well without supports. You dont need to add them for the slot the lid slides into
| CZ455_Lid_Original_Box.stl | 234.2KB | |
| CZ457MagBoxV2.stl | 12.8MB | |
| CZ457MagLid.stl | 357.9KB | |
| CZ457_Magazine_Box_V3.stl | 148.3KB | |
| CZSavageLidBlank.stl | 214.8KB | |
| CZ_452_Mag_Box_Lid.stl | 365.5KB | |
| CZ_512_Mag_Box_Lid.stl | 366.5KB | |
| SavageLidV1.stl | 1.5MB | |
| SavageLidV2.stl | 364.3KB |
