Cyclone Separator – Pentz Design 3D Printer Model
The file 'Cyclone Separator – Pentz Design 3D Printer Model' is (step,stl) file type, size is 1022.8KB.
The file 'Cyclone Separator – Pentz Design 3D Printer Model' is (step,stl) file type, size is 1022.8KB.
Designed using the measurements from Bill Pentz's Cyclone Calculator spreadsheet (© Copyright 2008 - William F. Pentz.) using the settings recommended for workshop vacuums (as opposed to powerful woodworking chip extractor blowers).
You will need to print or otherwise make adaptors for your hoses and dust receptacle. All bolt holes are for 4mm bolts. Its efficiency is untested but I would expect that this will be sensitive to the quality of printing and assembly, so not really worth me doing it for your benefit. If you are interested in the effectiveness of the design, check Bill Pentz's work out for yourself. http://billpentz.com/woodworking/cyclone/air_cleaner.cfm
| Air_Ramp.step | 13.5KB | |
| Air_Ramp.stl | 22.9KB | |
| Cone_-_Bottom_Half.step | 136.2KB | |
| Cone_-_Bottom_Half.stl | 316.1KB | |
| Cone_-_Top_Half.step | 272.9KB | |
| Cone_-_Top_Half.stl | 248.9KB | |
| Cyclone_Inlet.step | 736.6KB | |
| Cyclone_Inlet.stl | 510.4KB | |
| Cyclone_Outlet.step | 395.4KB | |
| Cyclone_Outlet.stl | 473.9KB | |
| Cylinder_-_Bottom_Half.step | 198.5KB | |
| Cylinder_-_Bottom_Half.stl | 338.2KB | |
| Cylinder_-_Top_Half.step | 226.8KB | |
| Cylinder_-_Top_Half.stl | 216.2KB |
