Cyberpunk Shelf 3D Printer Model
The file 'Cyberpunk Shelf 3D Printer Model' is (stl) file type, size is 24.2KB.
The file 'Cyberpunk Shelf 3D Printer Model' is (stl) file type, size is 24.2KB.
See the Cyber Shelf!
Can be used with or without LED lighting. I personally used a small battery powered LED strip, but I think a small RGB bulb would provide more even lighting.
The shelf is held to the wall using two #6-8 screws & anchors. Mounting distance between the two screws is 130 mm.
This is a decent sized print, coming in at roughly 250 x 134 x 160 high (mm). I used 40% infill (in retrospect I feel like this was overkill). Print time was approximately 36.5 hours.
Support material required is minimal, I only needed a little bit inside the screw mounting pockets.
Thanks for viewing,
Kyle
| Cyber_Shelf_-_K_V_Design.stl | 105.6KB |
