“Cut Indicator” For 40W Laser Cutter 3D Printer Model
The file '“Cut Indicator” For 40W Laser Cutter 3D Printer Model' is (stl) file type, size is 116.5KB.
The file '“Cut Indicator” For 40W Laser Cutter 3D Printer Model' is (stl) file type, size is 116.5KB.
Fixture to hold a red laser diode at the correct angle to show where the laser will cut.
You may need to pass a 6mm drill-bit through the angled hole if it's too tight.
Also, tap the hole in the side, 4mm, this is for a set screw..
I found it necessary to glue the threads of the lens on the diode to make it steady
The holes for the screws in the top are designed for 3mm taper-head screws.
..
| laser.stl | 291.5KB |
