Customizable Wall-mounted Holder 3D Printer Model
The file 'Customizable Wall-mounted Holder 3D Printer Model' is (gcode,stl) file type, size is 2.8MB.
The file 'Customizable Wall-mounted Holder 3D Printer Model' is (gcode,stl) file type, size is 2.8MB.
A wall-mounted holder for your stuff. Can hold a phone, keys, glasses, coins, cards…. I think it looks a bit like a face frog. You will need 2 screws to hang it.
Customisable: you can chose the color of each parts: the holder, the hooks, the brackets.
There are keyhooks and glasses hooks. The number of hooks is free, they are clip-on.
The key hooks fit tight to avoid any glue. Feel free to sand slightly the surface if it's too hard to clip them (same for the brackets).
I added a picture to show how print it. It's almost support-free but I recommend a raft for the glasses hook and for the holder plate. The plate will be visually better if printed alone.
The distance between the two screws' holes is 118mm. ( I added a tool for that.)
Gcodes are available, work for my sidewinder X1 but I think any 30x30cm printer should be fine
| 15mn_1g_hexahook_short.gcode | 433.8KB | |
| 19mn_2g_hexahook_long.gcode | 544.5KB | |
| 1h16_12g_brackets.gcode | 1.8MB | |
| 30mn_5g_key_hooks_V1.gcode | 1.1MB | |
| 39mn_7g_key_hooks_v2.gcode | 1.8MB | |
| 5h24_77g_holder_plate.gcode | 8.9MB | |
| brackets.stl | 120.0KB | |
| hexahook_glasses_long.stl | 114.3KB | |
| holder_plate.stl | 669.6KB | |
| hook_keys_V1.stl | 52.6KB | |
| tool_screws.stl | 60.8KB |
