Parametric mount for one of the most common run-out sensors, suitable for mounting inside an IKEA LACK table. Just cut a hole on the top of the table big enough for the sensor, and screw the mount in place. Also cut a hole in the bottom of the table for the filament output, and sensor cable.
Adjust the parameter of the .scad-model customizer if your filament sensor have different measurements.
| chamfered_edge.stl | 95.5KB | |
| Customizable_Filament_Run-Out_Sensor_Mount_For_IKEA_LACK.scad | 7.1KB | |
| rounded_edge.stl | 223.0KB | |
| straight_edge.stl | 94.9KB |
