Custom Chair Wheel 3D Printer Model
The file 'Custom Chair Wheel 3D Printer Model' is (stl) file type, size is 549.60 KB.
The file 'Custom Chair Wheel 3D Printer Model' is (stl) file type, size is 549.60 KB.
(UPDATE) 7 years on now since I first designed this wheel Im still using the original ABS wheel on the same chair. PLA wheels can last for a few years and mode of failure starts as de-lamentation of outer wheel contact area resulting in a blow out or flat wheel.
This is a solid customizable replacement for the standard 2 inch (50mm) office chair wheel with a 8mm pin . The wheels are very solid and my prototypes have stood up to 7 years of abuse with persons up to 250Lb . The wheel supports when printed in PLA seem to last for a few months at 250LB load ABS failed much faster for me but I need a better printer for ABS and I think Nylon might be a good choice but I haven't tested it. It is best to save and reuse the original chair support and remove the old axle from it and source the right size bolt.
I have additional fender designs in the works as well as wheel covers or hubcaps.
Also another wheel designed for 626ZZ bearings that would allow for a smaller axle M6 Axel bolt for those who may have a hand full of 626ZZ bearings on hand.
Be the first on your block to have the coolest wheels around.
| Chair_Wheel_2inch_50mm_V2_R3a.STL |
| Chair_Wheel_Bearing_Cover_V2_R3a.STL |
| Chair_Wheel_Fender_V2_R4.STL |
| Chair_Wheel_for_19mm_Bearing.STL |
| Chair_Wheel_Rear_Cover_for_19mm_Bearing.STL |
| Chair_Wheel_Support_Steam_Ring_R2.STL |
| Chair_Wheel_Support__R2_V2.STL |
