My Peugeot 206cc has cup holders in the glove compartment lid and those would fit more likely for an espresso cup rather than a normal cup. So, I designed a cup holder I could screw to the side of the dashboard. The cup holder will not interfere with opening the glove compartment lid, even with a cup in it. This revision 2.3 where I changed the thickness of the walls to make the print a bit less easy to break. I also added holes with a reduction to the mount for the screws, as I found out drilling them in with a handheld drill is a bit annoying.
Printing:
Ring & mount - Infill at 100% or additional Outer Walls. Printed from black Tinmorry PETG at 245° C and 40° C print bed, 0.2mm layer height and 60mm on a Sidewinder X1.
Make sure to have good adhesion on your print bed for the ring as well as for the mount.
| Tassenhalter-Holder-V2.3.stl | 21.8KB | |
| Tassenhalter-Mount-V2.3.1.stl | 43.4KB |
