Fix the rest of parts to black one with hot glue. I recommend to press them in the biggest, black part, against the flat surface, so you won't press them too deep.
Don't forget, to put magnets inside hollow parts.
Be aware that parts can be distorted from hot glue heat, if you made them out of PLA.
It is recommended to print the parts on raft, to eliminate the "elephant foot" (wider part bottom).
If you wish, you can print part with hole in ear, to make a keychain ;)
| CPHD_Black.stl | 480.6KB | |
| CPHD_Black_Keyring.stl | 485.3KB | |
| CPHD_Red.stl | 289.6KB | |
| CPHD_White.stl | 940.9KB | |
| MGMN_Black.stl | 1.8MB | |
| MGMN_Blue.stl | 680.9KB | |
| MGMN_Red.stl | 249.9KB | |
| MGMN_White.stl | 3.4MB |
