Cup Noodle Birds 2: The Flock Pecks Back
I wanted to update the original project and make it easier to print, require fewer screws, and be more glue friendly.
Original: https://www.thingiverse.com/thing:4947855
Changes:
Split the main body into two halves, reducing the support material required and a bit easier on the printer and print time.
Created a "smooth" body without a logo.
Revamped the "long chopsticks" top. The top no longer requires screws; instead, the chopsticks slide into a slot. This variant can still use screws for additional strength.
Included a base with a square attached to it, just for added support.
Logo and lettering can be printed separately and attached to the "smooth" body.
Added additional material to help support the screw holes in the body.
I included a few different tops, all of which can function as a feeder/birdbath:
Plain
Top Angled Chopsticks (use with "Chopsticks Short") to add a small perch
Requirements:
Glue for assembly and additional waterproofing
4 X 1.5" #6 or 35mm M3.5 Screws if using a round base, glue works too.
| B.stl | 748.5KB | |
| Base.stl | 1.8MB | |
| Bird_Logo.stl | 5.3MB | |
| Body_1.stl | 12.0MB | |
| Body_2.stl | 12.1MB | |
| C.stl | 487.9KB | |
| Combined.stl | 22.5MB | |
| Cup_Birds_Original.rar | 17.9MB | |
| IRD.stl | 1005.4KB | |
| Long_Chopsticks.stl | 311.3KB | |
| Long_Chopsticks_Top.stl | 762.1KB | |
| Lower_Logo.stl | 5.6MB | |
| S.stl | 663.9KB | |
| Short_Chopsticks.stl | 144.0KB | |
| Short_Chopsticks_Top.stl | 675.5KB | |
| Simple_Top.stl | 653.2KB | |
| Smooth_Body_1.stl | 1.0MB | |
| Smooth_Body_2.stl | 1.0MB | |
| Square_Base.stl | 1.7MB | |
| UP.stl | 959.5KB |
