I liked robomodell's LCD bezel, but it didn't fit my printer right, and the LCD was a bit too high for my viewing angle (I sit with eye-level about the same height as the printer and the top line was a little cut off)
So I re-mixed it to fix the issues that I had (the holes didn't line up on my CTC Dual and the LCD was too high in the mount). I also tapered the sides in a bit to allow for a wider viewing angle.
I did not use the front bezel, so it's not included in my re-mix.
NOTE The bottom cover plate needs to be notched out to clear the LCD, which sits about 15mm lower than before. See pics for details.
| ctc_lcd_bezel_re-mix.stl | 86.1KB |
