I wanted a detachable probe, found the quickdraw but realized that there was no mount or dock suitable...so I fixed that. This docks at -2 X 0 Y (front left)
You will need:
6x small round Neodymium magnets (6mmx3mm)
3x M3 20mm plus nut
Some wire
3-pin endstop micro switch without the lever.
The STL for the probe itself can be found below:
https://github.com/Annex-Engineering/Quickdraw_Probe
I'll upload my Klipper config when I get a chance.
This will probably also work for any of the Replicator printers.
| CTC-Quickdraw-Long-Dock.stl | 529.6KB | |
| CTC-Quickdraw-Mount.stl | 174.0KB |
