My CSI Hot Gun2 broke, so I designed and printed a replacement part. The end of the OE tool enclosure is very thin and weak. It allowed the cable to move around too much, even before it broke. The new part looks better and performs well in many regards.
This new part is much stronger than the original, but it's also more restrictive to airflow. Note that all the air coming out the working end of the tool must ingress through this part. I take no responsibility if this part causes problems with your tool. I did not perform any kind of thermo design.
You'll need two #2x3/8 sheet metal screws to clamp the two halves around the power chord. The OE screws can be used to secure it to the tool body.
| cone_left.stl | 940.7KB | |
| cone_right.stl | 958.3KB |
