I love my Creality Ender 3 printers very much. I decided to make a printable 3D model of the Ender 3. It prints in sections and is glued together. I didn't have too much time to spend on accuracy, but tried my best to keep the representation true.
All parts are printed, including the micro Benchy (STL not include as its easy to find and not mine)
The only parts not printed are the black and white wires, which I just cut to size and taped with strips of electrical tape and glued in position.
The build plate can be set with a piece of paper wedged in the joint to allow sliding back and forth or can be glued in place.
The rear motor for the bed was a last minute thought and I just printed the leadscrew.stl and stopped it short or just print full and cut motor off. Works fine.
The Ender Logo in white should be printed half below the bed as I left it full height to allow adjusments. I didn't glue my logo in, I like how it just sits neatly in the grooves of the bed.
Extrusions should be printed upright without supports, maybe a raft if you need it.
0.16 Layer height
Extrusion widths were brought down to 0.36mm to achieve detail.
I hope you enjoy this as much as I did.
It looks great sitting on the shelf.

If anyone would like to enhance this further/remix, feel free to.

Thank you.