Update: I fixed the bottom to be a single flat layer.
I remixed this remix for the CR-6 se. I ran it through Meshmixer and smoothed it out a bit. There was an odd hole that I filled in.
Best printed in a higher temperature plastic than the plastic you plan on cooling. Close proximity to the nozzle will warp and deform the ring causing it to sag and catch on your print.
| CR_6_Fan_Ring_Duct_MM2_3db_RF6.3mf | 151.4KB | |
| CR_6_Fan_Ring_Duct_MM2_3db_RF6.stl | 375.0KB |
