Crates 3D Printer Model
The file 'Crates 3D Printer Model' is (stl) file type, size is 1.5MB.
The file 'Crates 3D Printer Model' is (stl) file type, size is 1.5MB.
using these for a 3D rebuild of Incursion can be used for any other miniature game
.
wooden crates; w/lids
.
larger crate contains an internal lip to insert the sideboard shelf if needed
.
smaller crate requires you to glue (I use acetone) the two blocks to the underside of the crate; lining them up with the two connecting boards along the one side; creates a lift for the crate w/o the need to print with supports
.
I've updated the 34x55 file; I did not get any errors from this file while printing with the Rep2x or the Afninia printer but I did notice after importing it into Netfab some issues showed up during the analysis which my 3D printing software seemed to either ignore and/or fix.
| crate_-_25_mm_x_30_mm.stl | 1.7MB | |
| crate_-_34_mm_x_50mm.stl | 1.7MB | |
| crate_-_34_mm_x_50mm__repaired_.stl | 1.8MB | |
| crate_shelf_-_34_mm_x_50mm.stl | 429.2KB |
