Craftsman Router Table Inserts (FreeCAD) 3D Printer Model
The file 'Craftsman Router Table Inserts (FreeCAD) 3D Printer Model' is (FCStd,stl) file type, size is 62.4KB.
The file 'Craftsman Router Table Inserts (FreeCAD) 3D Printer Model' is (FCStd,stl) file type, size is 62.4KB.
This is a set of inserts for a Craftsman router table. Outside diameter is 3in. Instep diameter is 2+7/8". Thickness of outer rim is 3/32in. Total thickness is 3/16in. I copied the inner diameters from a set of inserts I saw on ebay. Inside diameters are 1 1/4in, 1 7/8in, and 2 1/8in. Costs $15 on ebay for a set of these and Cura says it costs about 70 cents for all three with 50% infill. I'm going to try PLA and if they don't hold up then I'll just reprint using ABS. FreeCAD source is included if you need a custom center size then you can make one easily.
Update: My print of these inserts got done and I went to try them out and they were a hair too snug. So I just got my rubber mallet and tapped each one in 2 to 3 times to shave that hair off. After that they fit incredible and pop in and out by hand. And the top is perfectly flush with the table because I measured everything with calipers first. Very nice results!
My printer driver steps/mm are calibrated with a dial indicator so your print fit may vary depending on how accurate your stepper calibration is.
| Craftsman_Router_Table_Insert_Large.FCStd | 11.9KB | |
| Craftsman_Router_Table_Insert_Medium.FCStd | 11.9KB | |
| Craftsman_Router_Table_Insert_Small.FCStd | 11.8KB | |
| Router_Table_Large.stl | 65.7KB | |
| Router_Table_Medium.stl | 65.7KB | |
| Router_Table_Small.stl | 65.7KB |
