This is a wall/under shelf battery holder mount for the matching craftsman batteries. I have mounts for all my other (dewalt) batteries and wanted the same for my craftsman batteries. I believe there are a few lines this may work with, but I particularly made this to fit the standard size C3 19.2V Lithium-Ion Batteries.

*For the bigger sizes/XCP use the Wall Only versions since the "roof" of the original only has clearance for the smaller standard size.

ADDED 1/22/19 Wall Only mount allowing fit of any size C3 battery.

ADDED 1/22/19 Wall Only v2 with thicker arms and no text allowing to be printed flat horizontally on the plate with NO supports. +Rounded off edges.

ADDED 1/23/19 Mini Version you drop the neck down through. No supports needed.

Resolution I was able to print at .25 when prototyping, but .2 is recommended for a cleaner look if that matters to you.
Infill 15-25% The higher the stronger the arms will be. Keep that in mind depending on the size [weight] of battery you are mounting. I've found 20%-25% to be sufficient.
Supports I printed without supports which is currently only a problem for the cut out spot on the arms of the original standard size design. It works without supports, but that overhang will be a little sloppy. HOWEVER, V2 NEEDS NO SUPPORTS WHEN PRINTED FLAT HORIZONTALLY ON PLATE.
Orientation Versions with text were printed vertically with the text side against the plate. The rest horizontally with bottom to plate.

I'm a graphic designer, but relatively novice to making 3D models for printing so I'm open to suggestions in making this better if you have any. Feel free to leave any requests as well. Thanks!

DONATIONS
If you appreciate this and maybe it helped make life a little easier, please consider supporting the designer by sending a tip.
Click "TIP DESIGNER" here.