Very basic Pittsburgh HT011 Dial Indicator mount for Creality CR10s. May work on other printers like Ender. This is the ubiquitous electronic dial indicator you can buy from Harbor Freight or Amazon
Tested to work on my CR10s using the built-in "Level Corners" mode, no disabling steppers or manual bed movement required. Position of the indicator is such that the tip does not drag on the bed surface when moving from corner to corner.
Not included in the print is a positioning dowel; I used a leftover from some IKEA furniture. Any round object between 5.75mm and 6mm diameter will work, including bolts or part of a pencil. You could very easily 3D print a dowel or bolt 1" in length to accomplish the task, or just check your junk drawer!
Prints in about 45 minutes on my CR10s. I used 100% infill, and standard CURA build supports "everywhere" to keep the locking lip accurate and the holes clean.
| DialIndicatorMount.stl | 211.7KB |
