CR7改裝渦輪扇物件風罩的設計，風扇規格請參考圖片（開口2015, 螺絲孔距50mm）
This is a fan duct design for blower fan (nozzle: 2015 mm, holes between: 50mm) on CR7/CR8/CR10
需要m3螺絲螺帽來鎖緊
Need some m3 screw and nuts
注意，需要改x的限位開關位置。
Please notice that I change my x end stop switch to avoid interference
http://www.thingiverse.com/thing:1304207
而且我讓加熱塊的電線是往後走
Also, my hot head wire is on back site.
The blower can be rotated easily to tuning the position to cooling.
This design is vary simple and weight light, hope you can design your design.
If the fan duct is not tight enough, it may be the tolerance of fan or print part. Just add double-sided tapes.
| blowerDuct_031.stl | 31.5KB | |
| blowerDuct_032.stl | 31.3KB | |
| blowerDuct_holder_for_cr7.stl | 97.8KB |
