This is a model of the original back cover for the CR-6 SE display and a modified version for an sd card extension. When updating the Firmware for the display you have to us a micro sd card which requires you to disassemble the display each time. I was getting tired of doing that every month, since I have been updating to every version on the community firmware from sebazzz91 on reddit. I had this sd card extension laying around from my old Anet A8 before I had octoprint. I included the .step and .f3d of both so it can be remixed easily.
Communtiy Firmware 6 reddit thread
https://www.reddit.com/r/CR6/comments/mefp8d/community_firmware_tune_it_love_it_release_6/
https://github.com/CR6Community/Marlin/releases
sd card extension
https://www.amazon.com/dp/B07WWVBK8V/ref=cm_sw_em_r_mt_dp_EGNHGKNZK0BDS8N1Q3XD?_encoding=UTF8&psc=1
| Cover.stl | 280.7KB | |
| Cover_with_sd_holder.stl | 498.1KB | |
| CR6_DISPLAY_COVER_v2.f3d | 165.9KB | |
| CR6_DISPLAY_COVER_v2.step | 116.9KB | |
| CR6_DISPLAY_COVER_with_sd_card_v4.f3d | 242.0KB | |
| CR6_DISPLAY_COVER_with_sd_card_v4.step | 184.2KB |
