CR-10 Mod – Frame Braces 3D Printer Model
The file 'CR-10 Mod – Frame Braces 3D Printer Model' is (SLDPRT,STL) file type, size is 12.2MB.
The file 'CR-10 Mod – Frame Braces 3D Printer Model' is (SLDPRT,STL) file type, size is 12.2MB.
My personal version of the braces for the CR-10/CR-10S frame.
My printer is a CR-10 with the dual Z motor Kit, plus belt and pulleys on the top for avoid lost of syncro between the two screws; I had to leave some free space for the installation and the regulation of the pulleys on the top of the upper brackets.
In my case, I can reach the full Z stroke of 400mm without interferences, but at the top I have very low clearance at 400mm stroke (~2 mm), so be aware of this!
The top bracket uses the OEM hardware (Screws, T- nuts, bearing and bearing cover ), the bottom one need 3 screws and 3 t-nuts each.
Needed two threaded bars M8 L=640mm, and 10 M8 nuts
Everything printed, and installed! Everything fit good, just for the Nut Covers I used a little of silicon for keep them in place.
Thanks
| [_Mk2__-_Bottom_Bracket_-_LH.SLDPRT | 239.2KB | |
| [_Mk2__-_Bottom_Bracket_-_LH.STL | 7.8MB | |
| [_Mk2__-_Bottom_Bracket_-_RH.SLDPRT | 257.2KB | |
| [_Mk2__-_Bottom_Bracket_-_RH.STL | 7.8MB | |
| [_Mk2__-_Nut_Cover.SLDPRT | 61.0KB | |
| [_Mk2__-_Nut_Cover.STL | 71.6KB | |
| [_Mk2__-_Nut_Knob.SLDPRT | 266.3KB | |
| [_Mk2__-_Nut_Knob.STL | 131.9KB | |
| [_Mk2__-_Top_Bracket_-_LH.SLDPRT | 289.5KB | |
| [_Mk2__-_Top_Bracket_-_LH.STL | 5.5MB | |
| [_Mk2__-_Top_Bracket_-_RH.SLDPRT | 311.3KB | |
| [_Mk2__-_Top_Bracket_-_RH.STL | 5.5MB |
![[Remix] CR-10 Fan Mod 3D Printer Model](https://cdn.3axis.co/assets/01/3c/80/39/013c8039-4123-4419-8d92-a6c862619f7d/images/b659cf07-c59d-42a4-8477-f6128dc40c99_thumb.jpg)
