CR-10 All-In-One Setup 3D Printer Model
The file 'CR-10 All-In-One Setup 3D Printer Model' is (stl,zip) file type, size is 1.7MB.
The file 'CR-10 All-In-One Setup 3D Printer Model' is (stl,zip) file type, size is 1.7MB.
This is my take on an all-in-one setup for my CR-10. All main parts I've used are listed below but this is not intended to be a step-by-step guide to duplicate my setup. My hope is some of the parts I modeled may be useful for your build.
I've published the other main components of this build as separate things that can be found at:
CR-10 Dual Z with top mounted stepper
Everything prints in the orientation supplied with no supports.
The only part I took from another source is the MKS display panel. I used the step file originally provided by lordwimsey.
| Bed_Mount_Plain.stl | 122.3KB | |
| Bed_Mount_RightRear_Bottom.stl | 335.0KB | |
| Bed_Mount_RightRear_Top.stl | 72.7KB | |
| Cable_Chain_Bed_Mount.stl | 448.2KB | |
| Cable_Chain_Bed_Mount_Top.stl | 66.7KB | |
| Display_Cable_Holder.stl | 75.7KB | |
| EF_Mosfet_Mount.stl | 113.2KB | |
| Electronics_Board_Frame_Bracket.stl | 138.0KB | |
| Frame_Riser_Corner.stl | 72.2KB | |
| Frame_Riser_Inline.stl | 107.0KB | |
| HB_Mosfet_Mount.stl | 100.1KB | |
| MKS_Gen14_Mount.stl | 79.6KB | |
| MKS_mini12864_Knob.stl | 1.1MB | |
| MKS_mini12864_Panel.stl | 612.6KB | |
| Panel_Front_220mm.stl | 14.8KB | |
| Panel_Front_35mm.stl | 6.3KB | |
| Panel_Left_Rear_130mm.stl | 11.8KB | |
| Panel_Right_Rear_130mm.stl | 11.9KB | |
| Panel_Side_220mm.stl | 15.2KB | |
| Power_Plug_Panel.stl | 109.6KB | |
| Power_Supply_Mounts.stl | 77.1KB | |
| RaspberryPi_Mount.stl | 316.3KB | |
| Step_Files.zip | 577.2KB | |
| Upright_Brace.stl | 61.8KB | |
| X_Endstop_Mount.stl | 238.9KB | |
| Y_CableChain_Lower_Spacer.stl | 88.8KB | |
| Y_Wiring_Access.stl | 40.7KB | |
| ZipTie_Anchor.stl | 59.6KB | |
| Z_CableChain_Mount_Lower.stl | 54.8KB | |
| Z_CableChain_Mount_Upper.stl | 78.9KB |
