This is the Corvo's Folding Blade (Ammnra inspired design)

This couldn't be possible without the help of @arcanedesigning / OKcalamity73 's files (Thank you so much for sharing!) which were a remix of ammnra's and the thingiverse design.
I made many quality of life improvements like color separation, eliminating wobble and mainly lengthening the blade. At extended it is 70cm long total, 43cm blade and 27.6cm hilt (8cm added). Also too many aesthetic adjustments to count. It is assembled very similarly to ammnra's design.

I've printed it on a bambu to pretty successful results. If your printer isn't as finely tuned you may have trouble with parts not sliding as freely.
Best to use PETG but I used PLA on everything BUT the tier lock, which needs to be something stronger than PLA. Be warned.

Hardware needed:
-Small rubber band for tier lock

• Short M3 screw for latch hinge
• wire dia. 2mm and wire dia. 1mm
• Maybe some silicone lube

Won't be answering any questions as I've moved on and it's a very old project too full of mistakes and poor workflow. I had no knowledge when starting this so a lot could've been done better. In the spirit of shareability, freedom of creativity and innovation, I'd love to just get it off my hard drive for other creators to tinker and have fun with. Enjoy!