Hi evryone, this is an airplane model rc electric. This one is specifically intendend to be a light weight printable electric rc plane. The focal point is the covering of the plane, i made same attempts to cover with paper tissue using vinilc glue at 50%.
Please if someone have a better idea give me an advice.
I make some photos to give you an idea of the steps to build this plane.
I will upgrade information, file and 3d printing parameter at every update.
Most parts must be printed with a single wall, some is better printed in vase mode (BE or BU parts of the wings.
| alettone.stl | 1.6KB | |
| attacco_ala_dx3gradi.stl | 773.6KB | |
| attacco_alettone_DX.stl | 3.0KB | |
| attacco_alettone_SX.stl | 3.0KB | |
| BE.stl | 4.6KB | |
| Bordo_alare_DX.stl | 7.7KB | |
| BU.stl | 2.4KB | |
| Capote_DX.stl | 4.9MB | |
| Centina_DX.stl | 531.1KB | |
| Centina_DX_alettone.stl | 530.7KB | |
| centina_SX.stl | 531.8KB | |
| Centina_SX_alettone.stl | 531.1KB | |
| Elev_Mob.stl | 75.5KB | |
| Fusoliera_-_Part_10.stl | 11.8MB | |
| Fusoliera_-_Part_11.stl | 4.9MB | |
| Fusoliera_-_Part_12.stl | 1.6MB | |
| Fusoliera_-_Part_14_1.stl | 337.5KB | |
| Fusoliera_-_Part_22.stl | 1.5MB | |
| Fusoliera_-_Part_23.stl | 1.1MB | |
| Fusoliera_-_Part_5.stl | 1.2MB | |
| Fusoliera_-_Part_6.stl | 1.6MB | |
| Fusoliera_-_Part_7.stl | 1.1MB | |
| Fusoliera_-_Part_8.stl | 406.9KB | |
| Fusoliera_-_Part_9.stl | 5.1MB | |
| Fusoliera_Coda_INF.stl | 3.3MB | |
| Ordinata_7.stl | 110.8KB | |
| piastra_servo_DX.stl | 441.3KB | |
| Tasselli_-_Part_1.stl | 71.6KB | |
| Tasselli_-_Part_2.stl | 71.6KB | |
| Traversa_DX_post.stl | 3.0KB | |
| Trav_DX_ant.stl | 178.8KB |
