Cooling Fan For Ikea Lack Housing 3D Printer Model
The file 'Cooling Fan For Ikea Lack Housing 3D Printer Model' is (stl) file type, size is 1.5MB.
The file 'Cooling Fan For Ikea Lack Housing 3D Printer Model' is (stl) file type, size is 1.5MB.
I added a cooling fan to my Ikea Lack Housing (https://www.thingiverse.com/thing:6710499) as i think it could get "pretty warm" inside as soon as i add the back wall...
I used:
The power comes from my Pi Housing as here is already a 24V to 12V converter installed and i made an Y-cable (two consumers on one distributor).
The top plate of the Lack table has already a hole in it for the outside vent cover and inside i worked a little bit, that the fan perfectly fits into the plate.
Mounted on and fixed wit the "Fan Holder and Cover Inside" it almost totally disappears.
This holder was initially created with this SCAD-File (https://www.thingiverse.com/thing:3733593), but was customized to hold the fan, too.
The controller comes into the corresponding box which is fixed from inside to the top plate.
On the photo there is the controller without the lid and taken from inside "upside-down".
Finally i fixed the cable down to the Pi Box (and power distribution) with a cable clip from here (https://www.thingiverse.com/thing:2185517)
| Fan_Holder_and_Cover_Inside.stl | 2.0MB | |
| Temp_Controller_Box.stl | 1.7MB | |
| Temp_Controller_Lid.stl | 1.7MB |
