This MOROTIZED CONVEYOR is simply a show and tell exercise. Turn the 2GT 300mm timing belt inside out to create the belt bins. The geared motor can be mounted inside a building or reversed and mounted under the layout. Make sure you place the timing belt inside the two halves before you glue them together.

I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two pieces of scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on styrene and PLA for years. No sloppy or messy glue to show when finished.

If you would like me to design a custom model for you contact me at:

[email protected].

It is totally free but I will post it on Thingiverse for others to print and enjoy.

Happy modeling,

Gary