100% tested
update: added the logo to glue in the top of case's logo you don't want to switch filament when printing the lid
This Box mounts on the 40mm extrusion vertically but with the usb facing the front of the printer.
The lid slides in from the top.
It houses the MKS Base control board and a MOSFET.
All holes are strategically placed , the circular ones are for the black tube, the slot ones for the rest of the wires (check diagram)
It uses the stock 40mm fan to flow the air out. The air enters through the slots refreshing all the enclosure.
0.2LH, 25%infill,
>= 4 perimeters
>= 4 top/bottom layers
no supports
1.1.1
1.1
| Control_box_case_v1.1.1.stl | 989.7KB | |
| Control_box_cover_v1.1.1.stl | 42.3KB | |
| Logo.stl | 45.2KB |
