This case is a remix from https://www.printables.com/model/415036-birthcontrol-travel-holder

This case is designed to hold contraceptive birth control blister packs that are 4 rows. The inside of the model contains two restrictive points that will grip the pack and keep it from falling out.

I SUGGEST PRINTING MODEL AND FACE PLATES WITH A BRIM.

MAKE SURE TO LET THE FACE PLATES FULLY COOL BEFORE REMOVING FROM THE PRINTER PLATE AS THEY WILL WARP EASILY IF STILL WARM.

This model is 94mmX55mm, It will hold a pill pack that is 83-88mm in length, and 50-60 in width. Due to the variations in different brands, you may want to scale a little in either direction to fit your pack. I would not suggest scaling down more than 5 percent.

If your pack will not fit, and you would like this case, please message me with your dimensions and I will try to make one that will fit your pills.

I have included 4 face plate designs and one solid face plate for your own customization.

Experiment with different surface patterns in your slicer to get the desired pattern. The "octogram spiral" on PrusaSlicer looks especially nice and will give you a starburst pattern. The "concentric" pattern looks nice on the two more detailed designs.

You can add 1 face plate to the holder or put one on each side without making it too thick. I recommend using E600 glue, an epoxy glue, or jb weld. E600 will be the easiest to use and has some flexibility. Make sure to glue the edges completely.