A contra-rotating propeller system consists of two propellers rotating in opposite directions co-axially. Not to be confused with counter-rotating propellers, which refers to two propellers rotating in opposite directions mounted on different locations (as in either side of the wing on an aircraft). For more information, refer to https://en.wikipedia.org/wiki/Contra-rotating_propellers/ .

This is a demonstration toy to show how bevel gears can be used to make coaxial shafts rotate in opposite directions. In a practical propulsion system, the inner shaft would be driven directly by the engine, and the outer shaft made to rotate in the opposite direction via the gear chain. As a demonstration toy, I made the handle to come out from the "intermediate" gear.

I was going to design this system with bearings for smooth rotation, but I scrapped the idea as it over-complicated the system, and I also wanted to design something that many people can build without the need to purchase additional parts.

I built in a simple locking feature for the handle; a piece of 1.75mm filament can be locked into the small hole so the handle will not fall off.

The stand is made just for displaying purposes. It is not a mandatory part of the system.

Simply print, and assemble!

A simple build video is available on YouTube: https://www.youtube.com/watch?v=HEANtxbMmus.

UPDATE Sept 2019:
Uploaded remaining files that were missing when this was first published.

If you would like to leave a tip, please check out my Ko-fi page! Really appreciate your support! https://ko-fi.com/plusalphadesigns