more parts to connect emt together.
I had a project that needed some other emt connections like this but it hasn't been needed as yet. I decided to make all the parts that I could think of needing. If you can think of another part you need, shoot me a comment and I will work on designing it.
I have not printed this out yet let me know if you have problems.
So far I have a:
Two part 90 ( one inside, one outside to attach one end to a middle)-print two-
Two part 45 (one inside, one outside to attach one end to a middle)
Two part 90 hub ( two inside, one outside to attach two ends to a middle)-print two-
Two part 45 hub ( two inside, one outside to attach two ends to a middle)
End elbow (two inside at 90)
End hub (three inside at 90
All parts are press fit and shouldn't need any screws but you can add one if needed.
| 45degree.stl | 142.0KB | |
| 45hub.stl | 206.7KB | |
| 90_hub.stl | 225.4KB | |
| conduit_4way.stl | 101.4KB | |
| Conduit_tee-half.stl | 65.6KB | |
| corner2way.stl | 111.6KB | |
| corner3way.stl | 166.2KB |
