Concrete Pot Plant 3D Printer Model
The file 'Concrete Pot Plant 3D Printer Model' is (stl) file type, size is 261.97 KB.
The file 'Concrete Pot Plant 3D Printer Model' is (stl) file type, size is 261.97 KB.
Simple concrete casted pot plant. Printed in pla, but its better if "potte part 2" is printed in flexible(easier to get out). I also used alot of release agent, its a bit hard to get it out if you used to little. but if you use enough you can just twist the part out. The walls is easy to get off and dont need release agent.
I didnt use concrete for the cast, i used screed for floors. It was super easy to mix and put into the 3d printed parts, and you dont get bubbles, just a nice smooth finish.
what you need:
2 parts of the potte part 1 v1
and 1 potte part 2
I added two version of the part 2. one is flatheaded, and the plants fits nice inside, but it's a bit hard to get out. The other is roundheaded and its easier to get out, but the plant dont fits as good as V1. If i would do this again i would choose V2.
After it was casted, i used "Hey'di sealer waterproofer" on the inside where the plant is so, the water doesn't just run throw. I also diped the cast in paint, and put some cork paper underneath so the concrete dont scratch anything.
| potte_part_1_v1.stl |
| potte_part_2_v1.stl |
| potte_part_2_v2.stl |
