Concorde Kit Card 3D Printer Model
The file 'Concorde Kit Card 3D Printer Model' is (stl) file type, size is 958.6KB.
The file 'Concorde Kit Card 3D Printer Model' is (stl) file type, size is 958.6KB.
The Concorde was a supersonic airliner that was produced by British Aircraft Corporation and Aerospatiale. It was introduced in 1976 and was used for 25 years by British Airways and Air France, until July 25, 2000, when a Concorde ran over debris on the runway during takeoff, killing everyone on board. the Concorde would later be retired in 2003 due to many factors, such as high maintenance costs, reduced air travel, and the incident in 2000.
This model was made at the behest of nottheshop, Thanks for the suggestion! I also included the obligatory Droop Snoot
Both Sprue and Sprue-less models included along with models of individual parts. If you are printing with the individual parts you will want:
Landing Gear Down:
Concorde Kit Card Fuselage Snoot Drooped x1
Concorde Kit Card Wing x1
Concorde Kit Card Engine x2
Concorde Kit Card Engine Gear Down x2
In Flight:
Concorde Kit Card Fuselage x1
Concorde Kit Card Wing x1
Concorde Kit Card Engine x4
while the fit is relatively snug, glue is recommended.
Print at a .2 mm layer height with 100% infill.
| Concorde_Kit_Card_Engine.stl | 8.2KB | |
| Concorde_Kit_Card_Engine_Gear_Down.stl | 88.8KB | |
| Concorde_Kit_Card_Fuselage.stl | 90.7KB | |
| Concorde_Kit_Card_Fuselage_Snoot_Drooped.stl | 112.0KB | |
| Concorde_Kit_Card_No_Sprue.stl | 165.6KB | |
| Concorde_Kit_Card_Snoot_Drooped_No_Sprue.stl | 303.5KB | |
| Concorde_Kit_Card_Snoot_Drooped_Sprue.stl | 979.4KB | |
| Concorde_Kit_Card_Sprue.stl | 854.4KB | |
| Concorde_Kit_Card_Wing.stl | 39.8KB |
