Yet another filament spool holder. Uses standard 608 bearings that can be found on cheap fidget spinners. This holder is just under 100 mm long, locks without additional hardware and side wall guides keep the spool over the bearings. 2 models. Latest update (white one) has lower guides.
A good enough printable bearing is here:
https://www.thingiverse.com/thing:3002837
My previous spool holder design is here:
https://www.thingiverse.com/thing:2791247
| SpoolRollerB.stl | 1.5MB | |
| SpoolRollerB_old.stl | 4.2MB | |
| SpoolRollerL.stl | 1.5MB | |
| SpoolRollerL_old.stl | 4.2MB |
