Comgrow/Sovol SH02 Dryer Filament Guide Fix 3D Printer Model
The file 'Comgrow/Sovol SH02 Dryer Filament Guide Fix 3D Printer Model' is (STL) file type, size is 491.5KB.
The file 'Comgrow/Sovol SH02 Dryer Filament Guide Fix 3D Printer Model' is (STL) file type, size is 491.5KB.
This is a fix to the sharp angle in the Comgrow/Sovol SH02 Filament Dryer Box. The factory guide would cause excess bends and jams causing failed prints unable to pull form the box. This puts it more of a vertical instead of a parallel feed function eliminating the strain.
Uses the factory screw, nut, and rubber seal to maintain air tight.
Print with high temp filament such as ABS/ASA because the inside does get up to 70C. PETG/PLA+ might be OK. No guarantee.
Can insert a PTFE tube on both sides or not. The inside hole is beveled so no sharp edges.
No supports needed! Print with the threads facing up!
| Filament_Guide_Base.STL | 38.8KB | |
| Filament_Guide_Top.STL | 988.8KB |
