A guitar shaped comb.
Recommended Print Settings:
300 - 400 Microns. ABS is good (feels soft on head) but do note that the comb teeth will warp. I printed this extremely slow (10-15 mm/s) because of the sharp corners. It's better if it is scaled in X and Y directions to make the corners/curves bigger.
Update: Printed with PLA, results were much cleaner. I have replaced the STL with a bigger version of the comb.
I have attached the Sketchupcup file. Feel free to make this better.
| ComboCaster2.skp | 334.7KB | |
| ComboCaster2.stl | 1.7MB |
