Collapsing Pirate Sword – Two Color 3D Printer Model
The file 'Collapsing Pirate Sword – Two Color 3D Printer Model' is (stl) file type, size is 1.1MB.
The file 'Collapsing Pirate Sword – Two Color 3D Printer Model' is (stl) file type, size is 1.1MB.
This is a remix of the extended version of the wonderful collapsing pirate sword by 3DPRINTINGWORLD. It provides for a different colored blade and hilt cap to be printed. My grandkids wanted specific hilt, pirate cap, and blade colors so this was the result.
The cap is intended to be glued in place. Krazy glue works really well for PLA.
4/21/2024: A blank pommel end cap has been added for those who have trouble with the engraved pirate king symbol version.
The files were easy to separate out and modify. I separated out the blade tip and flipped it around as I found it gave a better print. I cleaned up some rouge geometry in the hilt and flattened out the inside of the hilt cap to clean up that surface.
NOTE: Using thermally calibrated filament greatly helps with the quality of the print. I use these calibration clips in the link below to calibrate each spool of filament I print with.
https://www.thingiverse.com/thing:1037301
| Blades_Collection_CS.stl | 1.2MB | |
| blade_1_CS.stl | 231.8KB | |
| blade_2_CS.stl | 220.6KB | |
| blade_3_CS.stl | 223.0KB | |
| blade_4_CS.stl | 197.1KB | |
| blade_5_CS.stl | 184.8KB | |
| blade_6_CS.stl | 169.4KB | |
| Blade_tip_CS.stl | 246.7KB | |
| End_plug-Alt1_CS.stl | 157.5KB | |
| End_plug_CS.stl | 329.7KB | |
| Handle_CS.stl | 2.6MB |
