I used a geared motor that I had laying around, markings are Maxon motor 41.040.038-00.00-123.
You may be able to use other motors with a 1/4" shaft if you drill or move the mounting holes to match
I also included the source files for Alibre if someone wants to make changes.
I just uploaded a new set of files (9/12 6:35pm), the scape slot was too close to the motor and would jam the mechanism if two coins fell in at the same time.
(9/17) added a clip to make sure only one coin is carried to the sorter
(9/19) Complete overhaul of the rotor, comb and hole plate. Loose tolerances were allowing too many coins to be carried up at the same time so I reduced the size of the holes on the rotor and tighten up the slot under the comb.
| Base2.AD_PRT | 520.0KB | |
| Base2.stl | 296.8KB | |
| BaseAssy2.AD_ASM | 275.5KB | |
| Comb.AD_PRT | 208.0KB | |
| Comb.stl | 28.2KB | |
| holePlate.AD_PRT | 856.0KB | |
| holePlate.stl | 824.5KB | |
| Housing.AD_PRT | 1.0MB | |
| Housing.stl | 1.2MB | |
| IMG_2948.MOV | 31.1MB | |
| motor2.AD_PRT | 406.0KB | |
| rotor.AD_PRT | 1.1MB | |
| rotor.stl | 628.5KB | |
| tubes.AD_PRT | 1.2MB | |
| tubes.stl | 2.6MB |
