Tired of filthy spoons in the coffee jar? Tired of coffee abstinence making your hand shake and coffee going everywhere but in your coffee mug? Fear not! The coffee dispenser is here to help. Just place it over your cup and turn 1/2 way for 1 teaspoon of coffee (5ml). Turn again if you want more, easy!

No spare parts required. Everything can be printed (except the nescafe glass containter).
The Nescafé container that this print is designed for, has a inner diameter of 46.6mm. See photos.

Print instructions:
Print two DosierFasteners. One of each of the other stl files.
Use supports on top and bottom.
I printed using 0.2mm layer height on a prusa i3 mk2s.

Assembly instructions:
See video: https://www.youtube.com/watch?v=tqcsF8uFTTg
IMPORTANT: Note that the hole in the top part and the hole in the limiter should be on opposite sides. Otherwise you might just pour the whole bottle directly into your coffee cup. Adjust their relative position to each other by changing the pin's position in the top part. The limiter all ways need to be screwed on as tight as possible without braking the print.

• You might want to try the screws into the doser, before you do the assembly. it just goes smoother the second time you screw and makes for more easy assembling.
• You might want to take the foam from inside the nescafé lid, make some cuts and put it into the top part. That will make the top part more airtight and make the top fit nicer to the nescafé bottle. This is optional though.

Usage instructions:
Position the nescafé bottle over your mug. Turn the bottom part half a turn and coffee should be dosed.

Check out other useful prints over at www.youtube.com/ttgeek

I've been working on this design for 3 days now, so i'd appreciate a coin or two if you find it useful. Thanks!